Low pH Inhibition of Reductive Dechlorination

Organohalide-respiring bacteria are generally sensitive to pH. Reductive dechlorination of tetrachloroethene (PCE) to trichloroethene (TCE) and then to cis-1,2-dichloroethene(cDCE) can occur at a pH as low as 5.5. However, rates of cDCE reduction to vinyl chloride (VC) and then to ethene are reduced below a pH of 6.0. For efficient dechlorination to non-toxic end products, aquifer pH should be maintained above 6.0 during enhanced reductive dechlorination (ERD).

Related Article(s):

• In Situ Anaerobic Bioremediation
• Biodegradation - Reductive Processes
• Design Tool for Estimating Base Required during ERD
• pH Buffering in Aquifers
• Chlorinated Solvents

CONTRIBUTOR(S): Dr. Robert Borden, P.E.

Key Resource(s):

• Adaptation of a Dechlorinating Culture, KB-1, to Acidic Environments.
• Organohalide respiration with chlorinated ethenes under low pH conditions.
• Resilience and recovery of Dehalococcoides mccartyi following low pH exposure

Introduction

Enhanced reductive dechlorination (ERD) is commonly used to treat chlorinated solvents and related contaminants in groundwater by providing a fermentable organic substrate to serve as both an electron donor and a carbon source to stimulate microbially mediated reductive dechlorination. During ERD, the pH may decline as hydrochloric acid (HCl) is produced during reductive dechlorination and carbonic acid and organic acids are produced by substrate fermentation. However, dechlorinating bacteria appear to be particularly sensitive to pH changes with dechlorination of cDCE and VC to ethene completely inhibited at a pH of 5.5, resulting in a significant decline in degradation rates.

Effect of pH on Bioremediation Processes

Many biological processes are sensitive to pH. Most microorganisms important for subsurface bioremediation function most efficiently in near neutral conditions. Low pH can interfere with pH homeostasis or increase the solubility of toxic metals. Microorganisms can expend cellular energy to maintain homeostasis, or conditions in the cytoplasm and periplasm may change in response to external changes in pH. Some anaerobes have adapted to low pH conditions through alterations in carbon and electron flow, cellular morphology, membrane structure, and protein synthesis.

There is some evidence that organohalide-respiring bacteria are particularly sensitive to changes in pH. Pure cultures and consortia of organohalide-respiring microorganisms show highest dechlorination rates at circumneutral pH. Reduction of cDCE to VC to ethene is primarily carried out by strains of Dehalococcoides mccartyi (Dhc). Growth and dechlorination by Dhc occurs between pH 6 and 8, with highest activity measured between pH 6.9 and 7.5

Table 1 shows the range and optimum pH for growth of bacteria that reduce PCE to TCE and cDCE. Zhuang and Pavlostathis (1995) found that neutral pH was optimum for reductive dechlorination by a methanogenic mixed culture capable of dechlorinating PCE to VC. Vainberg et al. (2006) reported an optimum pH of 6.0-6.8 for dechlorination of PCE by the SDC-9^™ bioaugmentation culture. Dechlorination of PCE and TCE to cDCE can occur at pH down to 5.5.

Organism	pH Range	pH Optimum	Reference
Dehalobacter restrictus PER- K23	6.5 to 8.0	6.8 to 7.6	Holliger et al., 1998
Sulfurospirillum multivorans	5.5 to 8.0	7.0 to 7.5	Neumann et al., 1994; Scholz-Muramatsu et al., 1995; Yang, 2017a
Desulfitobacterium dehalogenans JW/IU-DC-1	6.0 to 9.0	7.5	Utkin et al., 1994
Desulfitobacterium sp. PCE-1	7.2 to 7.8	7.2	Gerritse et al., 1996
Desulfitobacterium dichloroeliminans DCA1		7.2 to 7.8	Fogel et al., 2009
Desulfuromonus chloroethenica TT4B	6.5 to 7.4	7.4	Krumholz el al., 1996;Krumholz, 1997
Desulfomonile tiedjei DCB-1	6.5 to 7.8	6.8 to 7.0	DeWeerd et al., 1990
Desulfuromonas michiganensis sp. Nov	6.8 to 8.0	7.0 to 7.5	Sung et al., 2003
Geobacter lovleyi SZ		6.5 to 7.2	Sung et al., 2006
(adapted from Damborský, 1999; Yang et al. 2017a)

Impact on Dechlorination Rates

Lacroix et al. (2014) examined the effect of pH on dechlorination rates for several organohalide-respiring consortia including SL2-PCEa, SL2-PCEb, AQ-1, and PM. Dechlorination rates as a function of pH (R_pH) were fit to the relationship:

where R_max is the maximum dechlorination rate at the optimal pH (pH_opt), and n and σ are empirical fitting parameters (Table 2). Graphs of relative dechlorination rates (R_pH / R_max) are shown in Figure 1. Dechlorination of PCE to cDCE can continue at pH below 5.5. However, dechlorination of cDCE to VC and VC to ethene is severely inhibited below a pH of 5.5.

(from Lacroix et al. 2014)

Figure 1. Relative Dechlorination Rates (R_pH /R_max) versus pH for Consortia SL2-PCEa, SL2-PCEb, AQ-1, and PM (adapted from Lacroix et al. 2014).

Low pH Tolerant Enrichments

Multiple researchers have attempted to develop enrichment cultures capable of complete dechlorination of PCE and TCE to ethene at low pH. However, to date, these attempts have had only modest success.

Rowlands (2004) reported that the KB-1^™ bioaugmentation culture has an optimal range of 6.0-8.3 and is completely inhibited below pH~5.0. Li (2012) found that rates of VC reduction to ethene by a KB-1 culture declined by a factor of two as the pH was reduced from 7 to 6. Ethene production rates declined slowly over time and multiple degradation cycles. The decline in ethene production rates was accompanied by a decline of Dehalococcoides (Dhc) numbers, increase in methanogens, and a shift in total electron equivalents consumed in dechlorination towards methanogenesis. In methanol fed pH 6 cultures, ethene production rates slowly increased over hundreds of days, with one culture showing sustained VC dechlorination at pH 5.7 (Li, 2012).

Using a bioaugmentation culture enriched from Savannah River Site aquifer material Eaddy (2008) found that dechlorination of PCE and TCE slowed at a pH of 6.0 with increased accumulation of cDCE and VC. At pH 5.5, reduction of cDCE to VC and VC to ethene was completely inhibited.

Yang (2017a) found that various dechlorinating pure cultures and the BDI consortium showed the highest dechlorination rates at circumneutral pH. Sulfurospirillum multivorans was the only organisms identified that dechlorinated PCE to cDCE at pH 5.5. Yang (2016) and Yang et al. (2017a) found that only one enrichment culture containing Desulfovibrio, Sulfurospirillum, and Megasphaera showed dechlorination of PCE to cDCE after repeated transfers at pH 5.5. After 40-days exposure to pH=5.5, Dhc lost the ability to dechlorinate VC to ethene (Yang et al. 2017b).

Overall, these results indicate that: (a) dechlorination rates are highest at circumneutral pH; (b) certain microorganisms can grow while dechlorinating PCE and TCE at pH values of 5.5 and lower; and (c) some Dhc-containing consortia can dechlorinate cDCE and VC to ethene during short-term exposure to pH 5.5. However, at pH 5.5, the consortia do not grow and gradually lose their ability to dechlorinate VC to ethene. As a result, complete dechlorination to ethene will be inhibited at low pH. In addition, several groups are continuing work on development of improved enrichment cultures that are effective at low pH.

Summary

Acids are produced during ERD that can cause pH to decline, inhibiting rapid dechlorination. Reduction of PCE to TCE to cDCE can occur at pH down to 5.5 or lower. However, rates of cDCE reduction to VC to ethene are reduced below a pH of 6.0. For efficient dechlorination to non-toxic end products, the aquifer pH should be maintained above 6.0 during ERD.

See Also

• Low pH Bioaugmentation Cultures
• Secondary Impacts of In Situ Remediation on Groundwater Quality and Post-Treatment Management Strategies